Jewelry Tools

The finest steel, milled to perfection with a diamond coating makes this 5pc set the best for precision filing jobs. Longevity is assured, as the diamond particles are electroplated onto the surface of the metal.

This 33-1/2″ long inner shaft should be used to replace broken or worn shafts on these discontinued motors:
F, JJ, JB.

A lightweight vise mounted in a wood handle. Smooth jaws are 1-1/4″ wide and open to 1″. Overall length is 6-1/4″.

Serrated, grooved, spring action jaws open and close with large wing nut. Handles are hollow so that long wire will pass through. Two jaw widths are available. Both open to 1/4″. Overall length is 4-1/2″.

Midget-sized hollow handle metal pin vise with screw chuck. Capacity 0 to .020″ (0 to .51 mm), overall length 1-7/8″.

The H.18 is for use with only 2.35mm (3/32″) shank burs.

H.15D has the same specs as the H.15, except includes a duplex spring for added flexibility.

The H.15 Handpiece has hammering rather than rotary action for use at low speed (0-5,000 rpm) by jewelers for stone setting and decorative work.

H.10 is a slender handpiece with rotating lever action that releases and closes the collet for quick and easy changes.

H.10D has the same specs as the H.10, except includes a duplex spring for added flexibility.

The H.8 is a slim collet type handpiece with pre-lubricated ball bearings that require no additional lubrication.

The H.30® general purpose handpiece has prelubricated ball bearings that do NOT require any additional lubrication. Comes with HPCK-0 Chuck Key in molded plastic handle for changing accessories.