Jewelry Tools
Browse Subcategories
Bead Tips or knot covers give your jewelry a professional finished look.
Stainless steel nylon-coated cord. Can be knotted and tied, but cannot be cut by rough edges of drilled stones.
.021″
Heavy
Make a perfect measured loop every time with Acculoop! Jaws clearly marked with measurements for making loops that range from 2 to 8mm. Length 6-1/2″.
Featuring two intense cleaning powers at the flip of a switch. Turbo Sweep Technology™ for the toughest jobs and Power Sweep Technology™ for more delicate jewelry.
Heavy duty 25 amp rectifier that can handle all of your plating needs.
This attractive, European designed all black ultrasonic is constructed out of contoured durable ABS. With its extra capacity of 2.6 quarts, it’s perfect for most retail jewelers and with its low cost, also makes a great back-up ultrasonic.
Plastic coating on tips provides chemical resistance. Use with steam cleaners and ultrasonic cleaners for non scratch retrieving. Cross lock version,mad of Nickel plated steel.
Metal: Stainless Steel
Length 6-1/2″
Point: Serrated tip
With fiber grips for heat resistance. Overall length 6-1/2 inches
Pair of motor brushes for discontinued CC, DD and MM motors (115 volt only).
Jewelers JKit – Great intro to Pacific Abrasives
Kit includes inner shaft, pair of motor brushes, grease, and operation manual.
37-1/8″ long standard material outer sheath for discontinued EE, GG, MMG geared motors and models 975, 980W, and 981W.
Our customers say that this is the world’s best 6pc wax needle file set. The teeth are finer and there are more teeth per inch than others.
The finest steel, milled to perfection with a diamond coating makes this 5pc set the best for precision filing jobs. Longevity is assured, as the diamond particles are electroplated onto the surface of the metal.
36-1/4″ long, standard material outer sheath comes equipped on most motors.
This 39-1/4″ long inner shaft should be used to replace broken or worn shafts on these discontinued motors:
EE, GG, MMG.
This 39″ long inner shaft comes installed and should be used to replace broken or worn shafts on various motors.
H.18D has the same specs as the H.18, except includes a duplex spring for added flexibility. H.18 is for use with only 2.35mm (3/32″) shank burs.
Has two steel chucks with spare chuck held in end of hollow brass handle. Will not roll off your bench. Capacity 0 to .079″ (0 to 2.0 mm).
The H.8 is a slim collet type handpiece with pre-lubricated ball bearings that require no additional lubrication.