Jewelry Tools
Browse Subcategories
The finest steel, milled to perfection with a diamond coating makes this 5pc set the best for precision filing jobs. Longevity is assured, as the diamond particles are electroplated onto the surface of the metal.
This 33-1/2″ long inner shaft should be used to replace broken or worn shafts on these discontinued motors:
F, JJ, JB.
A lightweight vise mounted in a wood handle. Smooth jaws are 1-1/4″ wide and open to 1″. Overall length is 6-1/4″.
Serrated, grooved, spring action jaws open and close with large wing nut. Handles are hollow so that long wire will pass through. Two jaw widths are available. Both open to 1/4″. Overall length is 4-1/2″.
Midget-sized hollow handle metal pin vise with screw chuck. Capacity 0 to .020″ (0 to .51 mm), overall length 1-7/8″.
The H.18 is for use with only 2.35mm (3/32″) shank burs.
H.15D has the same specs as the H.15, except includes a duplex spring for added flexibility.
The H.15 Handpiece has hammering rather than rotary action for use at low speed (0-5,000 rpm) by jewelers for stone setting and decorative work.
H.10 is a slender handpiece with rotating lever action that releases and closes the collet for quick and easy changes.
H.10D has the same specs as the H.10, except includes a duplex spring for added flexibility.
The H.8 is a slim collet type handpiece with pre-lubricated ball bearings that require no additional lubrication.
The H.30® general purpose handpiece has prelubricated ball bearings that do NOT require any additional lubrication. Comes with HPCK-0 Chuck Key in molded plastic handle for changing accessories.
This 1/8″ thick rubber cushion provides an added layer of comfort to H.30 and H.30SJ Handpieces. Grip slides on easily but holds firmly.
Foot operated speed control is made of heavy duty plastic with durable solid state electronics. The ergonomics allow precise and reliable speed control with your foot.
This foot operated speed control comes in a heavy cast iron metal housing. The extra weight provides added stability and control.
Tool steel collets grip firmly when screw chuck is tightened. Chromium-plated handles are hollow to permit holding of long wires.
Tool steel collets grip firmly when screw chuck is tightened. Chromium-plated handles are hollow to permit holding of long wires.
Includes Pin Vices: 0 to .040″, .025″ to .062″, .050″ to .125″, and .115″ to .188″.
Indented. Overall length 4-3/8 inches (111 mm). Sharp points.
Metal: Stainless Steel
Point: Medium Sharp
With pointed shank. Overall length 4-3/4 inches (121 mm). Sharp points.
Small holder fits in pocket. Wire jaws contract into body and plunger in end opens the jaws. Overall length 2 inches (51 mm).
For gripping and holding small objects. Plunger in handle opens wire jaws that contract back into handle. Overall length 4-3/4 inches