Jewelry Tools
Browse Subcategories
The “Original Ring Adjuster” Ring Snuggies provide a snug fit for a ring on any finger.
You save (%)
Kit includes inner shaft, pair of motor brushes, grease, and operation manual.
You save (%)
Made of the highest quality optical glass, this Optivisor 2.75X (#7) lens plate has a 6 inch focal length.
You save (%)
32-5/8″ long, standard material outer sheath comes equipped on ALL Flexades: S.B0-516, S.B0-14, S.B0-12, S.B0-38
You save (%)
This 33-1/2″ long inner shaft should be used to replace broken or worn shafts on these discontinued motors:
F, JJ, JB.
You save (%)
A lightweight vise mounted in a wood handle. Smooth jaws are 1-1/4″ wide and open to 1″. Overall length is 6-1/4″.
You save (%)
Serrated, grooved, spring action jaws open and close with large wing nut. Handles are hollow so that long wire will pass through. Two jaw widths are available. Both open to 1/4″. Overall length is 4-1/2″.
You save (%)
The H.18 is for use with only 2.35mm (3/32″) shank burs.
You save (%)
H.15D has the same specs as the H.15, except includes a duplex spring for added flexibility.
You save (%)
The H.15 Handpiece has hammering rather than rotary action for use at low speed (0-5,000 rpm) by jewelers for stone setting and decorative work.
You save (%)
H.10 is a slender handpiece with rotating lever action that releases and closes the collet for quick and easy changes.
You save (%)
H.10D has the same specs as the H.10, except includes a duplex spring for added flexibility.
You save (%)
The H.30® general purpose handpiece has prelubricated ball bearings that do NOT require any additional lubrication. Comes with HPCK-0 Chuck Key in molded plastic handle for changing accessories.
You save (%)
This 1/8″ thick rubber cushion provides an added layer of comfort to H.30 and H.30SJ Handpieces. Grip slides on easily but holds firmly.
You save (%)
Foot operated speed control is made of heavy duty plastic with durable solid state electronics. The ergonomics allow precise and reliable speed control with your foot.
You save (%)
Tool steel collets grip firmly when screw chuck is tightened. Chromium-plated handles are hollow to permit holding of long wires.
You save (%)
Tool steel collets grip firmly when screw chuck is tightened. Chromium-plated handles are hollow to permit holding of long wires.
You save (%)
Includes Pin Vices: 0 to .040″, .025″ to .062″, .050″ to .125″, and .115″ to .188″.
You save (%)
Indented. Overall length 4-3/8 inches (111 mm). Sharp points.
Metal: Stainless Steel
Point: Medium Sharp
You save (%)
With pointed shank. Overall length 4-3/4 inches (121 mm). Sharp points.
You save (%)
Small holder fits in pocket. Wire jaws contract into body and plunger in end opens the jaws. Overall length 2 inches (51 mm).
You save (%)
For gripping and holding small objects. Plunger in handle opens wire jaws that contract back into handle. Overall length 4-3/4 inches
You save (%)