Watch Case Tools
Browse Subcategories
Made for pocket and large watches popular today. Well-made solid metal holder fits in any bench vise.
Set of 3 Pins for L-G Opener “Multinotch cover”
The six tempered rings are precision-made to interlock so they will not slip. The sturdy cast frame fits into your bench vise and the small bar gives you the torque you need for stubborn case backs.
Replacement Tip for Horotec Case Opener MSA07.115 – 4mm
Configured to make opening certain cases easier this 3 opener is popular among many watchmakers. Simply place the blade under the case back and twist.
Economy case knife is 4″ long with hard plastic handle and tempered blade. Fixed blade does not fold into handle.
Artifex Abrasive Wheel Fine, SC80WP. Grit 80, foamed polyurethane. 100mm x 10mm x 6mm Hole. Made in Germany.
The EURO TOOL case press offers the best inexpensive case closer available. This is one of our most popular items and the closer we most recommend. Every bench should have one.
Provides maximum torque with little effort. 4 pairs of interchangeable pins (round, rectangle, knurled, curved). Large ergonomic top wheel for screwing and unscrewing with little effort.
Horizontal-type vise with center support allows for positioning blades on two sides at once. The blades are forced in with a few turns of the knob. Two pairs of blades included, 2mm and 4mm. Swiss.
Enables the range of Bergeon 5537 Rolex dies and Breitling dies to be used with Horotec MSA07.320, Horotec MSA07.363 & Bergeon 5700-Z waterproof case openers.
This steel tool is used to install the Rolex® screw on pushers into a Rolex® watch case. McCaw Co. is independent of and not affiliated with or sponsored by Rolex®. Warranty does not apply to non-genuine parts supplied by McCaw Co.
Horotec Key For Screw-on tubes Ø 3.00 mm. Replacement key for MSA03.621, MSA03.622, & MSA 03.623
Reversible tip featuring a .80mm straight tip and a 1.20mm forked end.
Use these convenient plastic stoppers to help save your watch battery while not wearing your watch. The small plastic pieces will ensure your crown stays pulled out. Available in six sizes: .50mm, .60mm, .70mm, .80mm, 1.00mm, 1.20mm, 10 pieces each.
Bestfit Springbar Removing Tool. Includes fine point and forked tip.
Set of four dies for opening Omega Seamaster case backs. Sizes included are: 20mm, 30mm, 33mm, 42mm. Swiss Made.
This is the replacement blade for the Right Handed Bergeon Case Opener Tool 6987.
5 Delrin® Screw-on Reversible Dies for Fitting Large Case Bezels
3 different diameter (25 – 30 – 33mm) Swiss made by Horotec
For opening and closing screw backs and bezels. Has two cup sizes for 0 to 18s watches.
We have had many calls for larger snap-on nylon dies to fit our CRY-905.00. This set is designed for larger oversized watches that are very popular, and most have snap-on case backs.