Shop

Replacement collet for H.10 and H.10D Handpieces. Holds accessories with 3/32″ shanks.

This 1/8″ thick rubber cushion provides an added layer of comfort to H.30 and H.30SJ Handpieces. Grip slides on easily but holds firmly.

The H.8D has the same specs as the H.8, except includes a duplex spring for added flexibility.

The H.8 is a slim collet type handpiece with pre-lubricated ball bearings that require no additional lubrication.

The H.30® general purpose handpiece has prelubricated ball bearings that do NOT require any additional lubrication. Comes with HPCK-0 Chuck Key in molded plastic handle for changing accessories.

Slender, tapered grip H.28 comes with 2 collets and accommodates accessories with shanks up to 1/8″. Key tip connection.

H.18D has the same specs as the H.18, except includes a duplex spring for added flexibility. H.18 is for use with only 2.35mm (3/32″) shank burs.

The H.18 is for use with only 2.35mm (3/32″) shank burs.

H.15D has the same specs as the H.15, except includes a duplex spring for added flexibility.

The H.15 Handpiece has hammering rather than rotary action for use at low speed (0-5,000 rpm) by jewelers for stone setting and decorative work.

H.10D has the same specs as the H.10, except includes a duplex spring for added flexibility.

H.10 is a slender handpiece with rotating lever action that releases and closes the collet for quick and easy changes.