Shop
Browse Subcategories
H.10 is a slender handpiece with rotating lever action that releases and closes the collet for quick and easy changes.
H.10D has the same specs as the H.10, except includes a duplex spring for added flexibility.
The H.15 Handpiece has hammering rather than rotary action for use at low speed (0-5,000 rpm) by jewelers for stone setting and decorative work.
H.15D has the same specs as the H.15, except includes a duplex spring for added flexibility.
The H.18 is for use with only 2.35mm (3/32″) shank burs.
H.18D has the same specs as the H.18, except includes a duplex spring for added flexibility. H.18 is for use with only 2.35mm (3/32″) shank burs.
Slender, tapered grip H.28 comes with 2 collets and accommodates accessories with shanks up to 1/8″. Key tip connection.
The H.30® general purpose handpiece has prelubricated ball bearings that do NOT require any additional lubrication. Comes with HPCK-0 Chuck Key in molded plastic handle for changing accessories.
The H.8 is a slim collet type handpiece with pre-lubricated ball bearings that require no additional lubrication.
The H.8D has the same specs as the H.8, except includes a duplex spring for added flexibility.
This 1/8″ thick rubber cushion provides an added layer of comfort to H.30 and H.30SJ Handpieces. Grip slides on easily but holds firmly.
Replacement collet for H.10 and H.10D Handpieces. Holds accessories with 3/32″ shanks.
Replacement collet for H.18, H.18D and H.18SJ Handpieces. Holds accessories with 3/32″ shanks.
Pair of motor brushes for discontinued CC, DD and MM motors (115 volt only).
36-1/4″ long, standard material outer sheath comes equipped on most motors.
37-1/8″ long standard material outer sheath for discontinued EE, GG, MMG geared motors and models 975, 980W, and 981W.
32-5/8″ long, standard material outer sheath comes equipped on ALL Flexades: S.B0-516, S.B0-14, S.B0-12, S.B0-38
This 39″ long inner shaft comes installed and should be used to replace broken or worn shafts on various motors.
This 39-1/4″ long inner shaft should be used to replace broken or worn shafts on these discontinued motors:
EE, GG, MMG.
This 33-1/2″ long inner shaft should be used to replace broken or worn shafts on these discontinued motors:
F, JJ, JB.
Sanding sticks (9-7/8″ long x 3/4″ wide) with 5″ x 3/4″ sanding surfaces. Each stick has 10 strips of quality sandpaper (5 on front – 5 on the back) attached in layers. Sturdy plastic construction and non-slip grip. Tear layers off to expose new sanding surfaces. Grits included: 180, 240, 320, 400, 600, 800, 1000, […]
34″ long Flexade converts a bench lathe, drill press or electric drill into a flexible shaft machine. Flexades are Right Side Specific when used with Foredom’s bench Lathe. See Product Options for choice of Flexade Coupling Size. 5/16″ coupling for current lathes. **Lathe and/or handpiece is not included.**